1994 Geo Metro engine troubles

RV and bus conversion info since 1996.

Share Your Feedback

PRINT PAGE

RV Classifieds

		1998 Newmar American Star - $15,000
		2006 Travel Supreme Select 45DL24 - $294,900
		2005 Newmar Dutch Star 4320 - $239,896
		1985 Monaco Crown Royale - $56,000
		2002 Beaver Marquis - $325,000
		VIEW ALL
		Search RV Classifieds
		Classifieds Policies
		Benefits for Dealers
		Sell Your RV
		Dealer Signup

Useful Links

RV Community

		Discussion Groups
		RV Articles
		RV FAQs
		RV Classified Ads
		Virtual RV Park
		Shop at our Store
		RV Lifestyle Books
		Rate Your RV
		AllThingsRV.com
		MyRVGuide.com
		RVMechanic.com
		Advertise With Us

BECOME A MEMBER

RV Resources

		e RV Loans
		Sculptures for your RV
		Visit Rio Rancho, NM for Winter
		RV Dealers
		RV Manufacturers
		RV Rentals
		RV Glossary
		RV Types
		RV Ratings

1994 Geo Metro engine troubles

Home > Discussion Forum > Mechanic's Corner - Engines

email Mike

reply to message

post new message

search forums

hidden layer

ATTENTION: All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.

All Messages in Thread	Author	Date
1994 Geo Metro engine troubles	Mike	10-3-07
Hello, I have a 1994 Geo Metro, 1.0L 3-cylinder engine, automatic transmission, with throttle body fuel injection. The car was running fine until on the way home from work it started to lose power. I was able to get it home only by keeping the accelerator to the floor. These are my current symptoms: 1. Starts hard. 2. After starting it has a rough idle. 3. If you try to "blip" the accelerator either during idle or while driving, it stalls. 4. It tries to cut out when you shift into gear. 5. I can hear light backfiring when letting off from full throttle. 6. It stalls when accelerating from a stop, unless I power-brake it to get the rpm up. It runs ok at mid throttle range but will not go above 55mph on a flat, straight stretch of road at full throttle. Low end throttle it stalls, high end throttle lack of power. I've verified the timing setting, replaced the plugs, wires, and fuel filter with no success. No engine codes stored. Any ideas? Thanks
Re: 1994 Geo Metro engine troubles	Jim Mizell	10-14-07
Having owned a couple of these, I feel you should check your compression first. These 3 cylinders are real bad about burning valves.
Re: 1994 Geo Metro engine troubles	BUBBA THE BUS TECH	10-3-07
I haven't worked on one of these for a while but... Do a compression test, had one that had the automatic lash adjusters for the valves stick and hold some of the valves slightly open. Virtualy no compression on two cylinders but would just barely start and ran better the higher the revs got. Just do a compression test, I dont know the spec, put the cylinder will run if its got over a hundred psi by rule of thumb. Plugged exshaust fits your symptoms pretty good. Cant rember how the catilist is mounted but basicly cut or undo the the pipe to the cat and see if it runs better. You can do this test with a pressure guage, but why spend the money, you will be able to tell imediately if this is the problem. An initial test i do is to have the car drive away from you at full throttle, if you can hear the normal rap or pulse of the engine its probably not plugged. If it sounds like a snake hissing away its probably plugged. The exception is late 70's fords they all sounded plugged. The other things are cap and rotor (very likely but they should have been changed with the wires) if this equiped with a distributor, and pattern comming from the injector. If you have a sensitive enough timing light it will sense the injector pulse and show you the pattern. My snap-on will. Anything other than a nice even cone of sprayed fuel is bad. Good Luck
Re: 1994 Geo Metro engine troubles	rodger schenk	5-15-08
What are lows and high for the compression check for 1994 geo 1.0 motor. thanks rodger schenk
Re: 1994 Geo Metro engine troubles	pj	5-31-08
I have a 92 metro..compression for a new motor is 205psi per cylinder..anything under 160 is rebuild time..new exhaust valves,stainless steel is best, compression is tested on a hot motor, throttle wide open and all plugs out..the new head gasket will have the ouil return holes way too small..you can see this when you place the gasket on the block..upper right and left corners..enlarge them other wise oil doesn't draon back fast enough and you will have a smokescreen behind you..it;s a known problem..but noone has corrected the gasket at any of the manufactirers
92 geo metro 1.0 3 cyl manual trans	william	9-12-08
I have a 92 geo metro with a few problems, there is no spark to the plugs, no voltage to the coil, or the wires connecting to the coil. i replaced the cap and rotor, added new wires, all fuses are good. still nothing. neutral saftey switch is good. timing is good. my second problem is that my fuel injector is not being engauged, i have fuel pressure, and the fuses are good also. i got a scan tool and checked for any existing codes and found nothing, does any one have any idea what the problem would be ?
Re: 1994 Geo Metro engine troubles	mark	6-24-08
Its the cats. One at the exhaustmanifold and the mid pipe one. Change them.
Re: 1994 Geo Metro engine troubles	David B. Cyphers	10-15-08
Same here on mt 91 auto. geo metro. it was my timing belt broken and found part of a piston in my oil pan. good luck