 |
I need some help. I have not seen this specific problem discussed but it is similiar to those above.
I have an 84 28' P30. Everything worked before except for a right then left pull as the calipers did not apply simultaneously.
I changed the calipers, pads, and flex lines.The problem is that I cannot bleed the brakes now. The fluid will not leave the reservoir but will stay there. I have tried flushing it through, cracking the bleeder under pressure, engine on, engine off, etc. It seems as if the front chamber of my master cylinder is full of air which does not want to leave.
I am an RV newbie but have 30 years of experience with cars, boats, race cars, etc. I have missed something obviously. I expect that I have jammed the piston to the end of the brake switch but have been unable to find it yet... or something similiar.... but am open to suggestions. The master is up above the driver front wheel so access is very limited. I will focus on that area as I start today.
Please help.
Thanks!
Greg |
RV and bus conversion info since 1996.
email Greg
reply to message
search forums