Motorhome & Recreational Vehicle Resource

Since 1996

Search RV-Coach Online

Email Author email Bill  Reply to Message reply to message  Post New Message post new message      search forums
ATTENTION: DO NOT POST ADS IN FORUMS!
All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.
All Messages in ThreadAuthorDate
P-30 Brake Problem Solved! Bill 3-17-03  
This is a post in regards to a post two pages back. Master cylinder was replaced on a Hydo-boost brake system. The brakes which are four wheel disc were gradually looking up, then would seize. The solution was that the brake pedal switch was too far foward not allowing the pedal to fully return. This didn't let the fluid back into the master, gradually pressurizing the lines. The fluid as it was heated expanded causing the calipers to lock. I hope this is helpful sounds simple but was a head scratcher, thanks to the guys that tried to help out.
Re: P-30 Brake Problem Solved!(requirement) Tonga Monu 6-8-03  
To Whom It May Concern,

Sorry for doing this in your program, plus my request is not in your messages require. However, I look at your Web and read your program and very interested for me. Please I am a student and I have a prject to do the topic is about the brake problem but base on the (OVERHEAT OF THE FLUID)Please if you have a comment about this topic it is very impressive to me to have it. sorry for your time and have a good day.

thank you
Tonga Monu
tmonu@xtra.co.nz
Re: P-30 Brake Problem Solved! frank burder 11-28-04  
Please let me know if you still have no problems with your brakes. My p-30 motorhome has had both front calipers replaced and the master and still they lock UP!! thanks in advance frankburder@aol.com
Re: P-30 Brake Problem Solved! Minh Nguyen 4-3-07  
Frank, check and replace brake flex cables (rubber brake line that connecting to brake caliber) and also check brake fluid to make sure it clean and correct fluid use.
P30 Hydroboost russell 11-12-07  
Installed new ps/pump and bled the system and the ps and pb works and it is quiet until you pull it into Gear then it starts to make noise and loses ps pb.Can anyone tell me why this is happening?
Russell
Required fields in red
For more info about a field, place your mouse over the More Info icon.
Subject:
Your Name:
Your Email:
Message:



Code is case-sensitive. Helps stop SPAM.
       


Advertise Here
Get Media Kit NOW!






Get Media Kit to Advertise!

Advertiser Links

Back to Top