Search RV-Coach Online
|email Cass Jasso reply to message post new message search forums|
ATTENTION: DO NOT POST ADS IN FORUMS!|
All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.
|All Messages in Thread||Author||Date|
|Purging power steering and brakes||Cass Jasso||12-18-12|
|Could someone tell me how to purge the power steering and brakes on a 1993 bounder MH (p30)?|
Where is the master cylinder located?
|Re: purging power steering and brakes||BUBBA THE BUS TECH||12-21-12|
|The power steering pump powered hydraulic boost system can be a pain but basically, fill the resivour, put on cap, run engine for probably a few seconds the first and second times, top it up after the foam goes away.|
Then let it idle and keep topping it up until the foam in the tank is gone, step on the brakes, turn the steering from lock to lock, top up repeat.
Once it seems to be good, put the lid on and then shut it off.
If the cap blows oil, it wasn't purged, start over.
The master cylinder can be under the floor, under the dash or inside the "Hood" in direct line with the brake peddle.
|Re: purging power steering and brakes||rick||9-5-14|
|I have a1984 honey w/454 gmc, after replacing a brake line I bled the brakes, but still mhave no brakes the master cly is full, their is a large hose running from the front of the master cly to the power stering pump.. ive never heard of hyd boost brakes, or mixing brake fluid with power steering fluid,.,. do I use the same method described above achive brake???????|