Motorhome & Recreational Vehicle Resource

Since 1996

Search RV-Coach Online

Email Author email TomC  Reply to Message reply to message  Post New Message post new message      search forums
ATTENTION: DO NOT POST ADS IN FORUMS!
All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.
Re: Begining the Conversion : Gillig Phantom by TomC
Post New Message Strip the interior, check for cracks and fix them (especially around the doors), wire brush the frame and re prime with Rustoleum, make sure the floor is sound. I then screwed in spaced 1x2"s at about 1 foot spacing to anchor the walls, cabinets (overhead used 1x3 ash) ran the electrical that was needed in the ceiling (other electrical and plumbing is external from the walls for service) then had spray foam to the level of the 1x2"s for a total thickness of 2.25", lined the walls with 1/4" plywood and 1/8" on the ceiling. At this point you should run the electrical and plumbing. After that, start at the back of the bus and work forward. Do one job at a time and don't think about the other jobs until you finish that one job. If you think about the whole project, you'll go into overload. Just think of it as a bunch of small projects and pretty soon you'll see progress. Good Luck, TomC
All Messages in ThreadAuthorDate
Post New MessageBegining the Conversion : Gillig Phantom Brittany 8-7-05  
  Reply to MessageRe: Begining the Conversion : Gillig Phantom TomC 8-9-05  
  Reply to MessageRe: Begining the Conversion : Gillig Phantom Kyle 10-18-05  
Required fields in red
For more info about a field, place your mouse over the More Info icon.
Subject:
Your Name:
Your Email:
Message:



Code is case-sensitive. Helps stop SPAM.
       


Advertise Here
Get Media Kit NOW!






Get Media Kit to Advertise!

Advertiser Links

Back to Top