Motorhome & Recreational Vehicle Resource

Since 1996

Search RV-Coach Online

Email Author email chuck  Reply to Message reply to message  Post New Message post new message      search forums
ATTENTION: DO NOT POST ADS IN FORUMS!
All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.
All Messages in ThreadAuthorDate
Stewart warner gauges chuck 9-16-04  
I need a wiring diagram for any of the following 6 pin SW gauges:
1. epeedometer
2. tachometer
3. oil pressure
4. transmission temp and or pressure
5. water temp
6. battery

any info would be greatly appreciated!

thanx much, Chuck
Re: stewart warner gauges Jim McNaul 9-25-04  
I have installed quite a lot of aftermarket Stewart Warner guages and am not familiar with what you mean by 6-pin. Most guages need (1) a light feed for the internal lighting,(2) a ground,(3) a 12-v steady off the ignition switch,(4) and a wire to the appropriate sensor.I can't picture a need for 6 connections. I would contact Stewart Warner. Have any numbers off your guages handy.
Re: stewart warner gauges Kury 12-8-04  
I Imagen you have already figured this problem out but the 5 of the 6 wires should be:

1. ignition Positive
2. Constant Negitive
3. Light Neg (aka Const Negitive)
4. Light Positive
5. Sensor wire to the sending unit
6. ?

or read it all from Stewart Warner at:
http://www.sw-performance.com/Tech/1elecII.html
Re: stewart warner gauges jack Goetz 2-11-08  
When you say a 12v steady off of the ignition switch what wire do you mean? Do you mean connect to the wire that goes to the HEI distributor that says battery?

Jack
Required fields in red
For more info about a field, place your mouse over the More Info icon.
Subject:
Your Name:
Your Email:
Message:



Code is case-sensitive. Helps stop SPAM.
       


Advertise Here
Get Media Kit NOW!






Get Media Kit to Advertise!

Advertiser Links

Back to Top