ATTENTION: All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.
Hello, all. Am in the D/FW, Tx area and need some help on replacing at least the drivers side torsilastic suspension on a 75 Eagle 05 shell. Its leaning to the drivers side pretty bad. No adjustments left. Only a little bit MIGHT be left on the passenger side. Any suggestions or references? Thanks, RW
The bar may be junk. Look at the adjustment nuts. see the spacers? On one side they are long. On the other side of that big bolt,the spacer is short, just turn the spacers around and you can raise your coach quite a bit. If the bar is ok, adjust it into or way into the nut an weld the inside of the nut closed. that will be your final adjustment!Also put a good set of gas shocks on the steer axle. also weight transfers in an x pattern so make sure you dont have a broken or frozen shock on any corner that is pushing your low corner down. If you try to adjust the bar, cut a 4 inch wide hole about 10 inches long behind each bar adjustment nuts in the front cargo bay and you can sit in there with your 1 and 1/4 in wrench or 1 and 1/2I dont remember, however the wrench is about 24 inches long and I scab welded a piece of square tubing about 30 inches long on to the original wrench for leverage, thems some", big nuts", but they will move, even if its only a little!