Get information on Eagle, GMC, Prevost, MCI and other bus conversionsRV and bus conversion info since 1996.
Share Your Feedback    
       
 
  PRINT PAGE 
 
 
RV Classifieds
  1990 Eagle Model 15 - $75,000
  1977 MCI mc8 - $96,000
  2003 Lance 920 - $14,600
  1999 Airstream cutter 35' diesel pusher - $85,000
  1984 MCI MC-9 - $19,950
  VIEW ALL
  Search RV Classifieds  
  Classifieds Policies
  Benefits for Dealers  
  Sell Your RV  
  Dealer Signup  
 

Useful Links
 
RV Community
  Discussion Groups  
  RV Articles  
  RV FAQs  
  RV Classified Ads  
  Virtual RV Park  
  Shop at our Store  
  RV Lifestyle Books  
  Rate Your RV  
AllThingsRV.com
  MyRVGuide.com  
  RVMechanic.com  
Advertise With Us
BECOME A MEMBER
RV Resources
RV Storage in New Mexico
Free Car Buying Advice
Sculptures for your RV
Visit Rio Rancho, NM for Winter
  RV Dealers  
  RV Manufacturers  
  RV Rentals  
  RV Glossary  
  RV Types  
  RV Ratings  
 

Dometic RM2310 2 way

Home > Discussion Forum > Mechanic's Corner (general)

Email Author email Trish  Reply to Message reply to message  Post New Message post new message      search forums
hidden layer
ATTENTION: All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.
All Messages in ThreadAuthorDate
Dometic RM2310 2 way Trish 9-14-09  
Lp-gas does not cool fridge (50) when outside temp. @ 80. Freezer remains frozen. Troubleshooting guide suggests removing burner jet and soaking in wood alcohol. However there are no instructions on how to remove the burner assembly. A drawing would be helpful. Also, I have been unable to remove shelves for cleaning because I can't release the shelf locks. Used 1994 Roadtrek. Any suggestions?
Re: Dometic RM2310 2 way Keith 9-14-09  
Hi Trish, This is right from the manual:

The Burner and the Burner Jet
The color of the flame should be clear blue over the slots of the burner.
Once or twice a year depending on use, it is necessary to clean and adjust the burner assembly. Proceed as
follows:
1 Loosen screw and remove cover plate for burner housing.
2 Disconnect lighter cable from the electrode.
3 Loosen burner fixing screw and withdraw burner.
4 Clean burner tube with a brush. Blow with compressed air.
5 Unscrew jet and clean with alcohol. Blow with compressed air. Never use a needle or similar instrument to clean jet.
6 Reassemble.
7 Be careful that the end of the burner fits into the slot on the bracket.
The slots of the burner must be centrally located under
the boiler tube.
If it doesn't cool on electric either you may be looking at a bad cooling unit.
As for the shelf locks, if they're square and sit in a recess in the side, pry the center out, then slide out the shelf. Good luck
Required fields in red
For more info about a field, place your mouse over the More Info icon.
Subject:
Your Name:
Your Email:
Message:



Code is case-sensitive. Helps stop SPAM.
       



Call for pricing
PRIVACY POLICY  |  TERMS & CONDITIONS  |  © 1996 - 2009 RV-Coach Network - All Rights Reserved  |  Web Site by ITtelligent