1986 Lindy Class "C" dual fuel tanks

RV and bus conversion info since 1996.

Share Your Feedback

PRINT PAGE

RV Classifieds

		1980 MCI MC-9 - $54,995
		1978 MCI mci mc-8 - $55,000
		1988 Fleetwood Limited with 1995 Ford SW Toad - $26,950
		1985 Monaco Crown Royale - $56,000
		1987 GMC RTS - $10,500
		VIEW ALL
		Search RV Classifieds
		Classifieds Policies
		Benefits for Dealers
		Sell Your RV
		Dealer Signup

Useful Links

RV Community

		Discussion Groups
		RV Articles
		RV FAQs
		RV Classified Ads
		Virtual RV Park
		Shop at our Store
		RV Lifestyle Books
		Rate Your RV
		AllThingsRV.com
		MyRVGuide.com
		RVMechanic.com
		Advertise With Us

BECOME A MEMBER

RV Resources

		Best Rate RV Loans
		e RV Loans
		Visit Rio Rancho, NM for Winter
		RV Dealers
		RV Manufacturers
		RV Rentals
		RV Glossary
		RV Types
		RV Ratings

1986 Lindy Class "C" dual fuel tanks

Home > Discussion Forum > Mechanic's Corner (general)

email Dave

reply to message

post new message

search forums

hidden layer

ATTENTION: All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.

All Messages in Thread	Author	Date
1986 Lindy Class "C" dual fuel tanks	Dave	7-29-08
Just bought and ran into a problem with filling the forward fuel tank. When trying to fill could only get 6 gallons of gas in the tank and then the gas pump would quit becasue the filler neck was full of gas. Figured that if I drove for a little bit (about 5 miles) that I could get it to go down. No luck. Also curious if the tank is empty will the boost pump in the tank still run?
Re: 1986 Lindy Class	Joe	8-4-08
Need a bit more info.....what chassis is it on? More than likely you don't have a pump in the tank, and if you did, it wouldn't be running when you switch tanks.
Re: 1986 Lindy Class	Dave	8-5-08
A little more info...It is on a Ford F350 chassis. Found that the rear tank pump was not working. Dropped the rear tank and wanted to change the pump and float unit but had a hard time getting the whole unit. Replaced the pump and it is working and am able to get the tanks to read full with the rear float pushed to the full position. Getting ready to put back together....we shall see.